GM-6A Deep Foundation DTH Auger Jet Grotuing Drilling Rig
GM-6A is multipurpose clawer type full hydraulic engineering drilling rig.
1. The shell: the installation of the shell shape makes the machine more scientific, but also protect the key hydraulic parts from pollution.
2. Outriggers: Not only to allow the cylinder from damage, but also enhance the support strength.
3. Console: split console, make the operation more simple, to avoid misuse.
4. Track: longer and stronger track, effectively prevent sagging, to adapt to a wider range of strata.
5. Lifting: Adjustable orifice height, no longer depends on the level of the face.
6. Automatic turntable: eliminating manual labor, easier and more convenient.
7. Through-hole high pressure faucet: the necessary equipment to expand the head construction.
8. Power head: The drilling machine gyrator is driven by a double hydraulic motor, with big output torque and lower swing center than similar products, which greatly improves the balance of drilling rig drilling. Expansion joints configured to greatly extend the drill pipe thread life.
9. Cooling system: According to the customer's special conditions, the cooling system is optimized to ensure that the hydraulic system when the outdoor temperature is 45 ℃, the maximum temperature does not exceed 70 ℃.
GM-6A Jet Grouting Drilling Rig is mainly used for rotary drilling, auger drilling, pneumatic DTH hammer drilling, follow-up drilling, and high-pressure jet grouting .
Application of construction:
1. Tunnel pipe-shed support, advanced forecasting
2. Deep foundation
4. Blastholes in open-air quarrying ,
5. Anti-floating anchoring
6. Geothermal pump holes,
7. Hydrological wells
8. geological disaster control.
|Drilling hole diameter||φ50-φ200mm|
|Drill pipe diameter||φ50—φ89|
|Power head speed||Low:0-60r/min High: 0-120r/min|
|Power head torque||8000N.m-4000N.m|
|Power head stroke||3400mm|
|Maximum feed force||30kN|
|Maximum pulling force||65kN|
|Arm sliding stroke||900mm|
|Arm pitch angle||90°~ -10°|
|Arm swing angle||±25°|
|Horizontal hole height||High:3100mm Low: 2100mm|
|Dimensions of drilling rig||L:5m×W:2.2m×H:2.3m|
|Contact Person :||Hannah|